CNC Electronics West Inc. 1445 Tidelands Ave, National City, CA, 91950. Tel: 619-477-9011
GE Fanuc « GE Fanuc Testing
|GE Fanuc testing is available. CNC has over 100
test rigs for GE Fanuc control boards, drives, monitors, motors, power supplies,
keyboards and encoders. The GE Fanuc fault diagnosis is mostly done from GE Fanuc
CNC controls. The test rigs include all series 6, one 3 rig, 10 and 11,
both analog and digital OA controls, full series of OB controls and several
variants of OC controls, with an i series control for FSSB series Alpha
drives. Motors and drives are tested within closed loop GE Fanuc cnc systems,
with feedback to the either the control or the drive amp. Test charges range
from $80.00 USD to $500.00 USD dependant on complexity, and does include
cleaning of the item.
CNC can test parts for faulty diagnosis, however if the fault is not on the part being tested then we may suggest looking at other possible causes, though this is not mandatory, and is the job of the engineer on site, not CNC's.
2012 © CNC ELECTRONICS WEST INC